Quick Summary
The right caravan storage unit size is your caravan’s measured length, width and height plus clearance on every side. Add at least 300 mm to each side, 500 mm at the drawbar end, 300 mm at the rear and 200 mm above the highest point. Confirm the clear opening dimensions with the facility before you book.
- Measure length, width and height in millimetres, including accessories that stay fitted.
- Add 300 mm of side clearance on each side, plus 500 mm at the drawbar end.
- Add 200 mm of overhead clearance above the roof vent, air conditioner or aerial.
- Ask for the clear opening dimensions, not the nominal bay size, before booking.
Table of Contents
- How to Measure a Caravan for Storage
- Caravan Storage Dimensions: Matching Unit Size to Caravan Type
- Allowing Caravan Storage Clearance for Access and Manoeuvring
- Checking Vehicle Height and Access Before You Book
- Caravan Storage Preparation Checklist Before the Unit
- Your Next Step: Measure, Confirm and Book Your Unit
- Frequently Asked Questions
Why Caravan Storage Unit Size Matters More Than Most Owners Think
Choosing the right caravan storage unit size matters more than most owners expect. Too small and the van will not fit; too big and you have empty space.
Caravan owners can guess at the size or assume the listed unit dimensions tell the whole story, then find the caravan is wider or taller than they thought, or there is no room to open the door once parked.
The core issue: a unit’s internal size is not the same as the space you can actually use. Treat the size as a working space, not just a box.
How to Measure a Caravan for Storage
Start with a tape measure and a flat, level spot near the caravan. Measure at the widest and tallest points, and do not rely on the manufacturer’s listed figures alone, add-ons and fittings often change the real size.
Work through these steps in order:
- Measure the length from the front of the drawbar to the rear bumper or back wall.
- Measure the width at the widest point, including awnings or side fittings.
- Measure the height from the ground to the highest point, such as the roof vent or aerial.
Length, Width and Height: What to Include
Include everything that will sit in the unit with the caravan: full length, full width at the widest point and full height at the highest point. A roof-mounted air conditioner or solar panel can add height you will not notice until the unit door is partly closed.
Measure again after fitting any extras, a figure taken before a bike rack or external gas bottle is added will be wrong.
Should You Include the Tow Hitch and Accessories?
Yes. Include the tow hitch in your overall length, because it sits inside the unit with the van. Add any accessories that stay attached during storage, such as a fitted awning or external storage box.
Remove and store loose items separately if you can. This keeps the caravan’s measured footprint accurate and gives you more room to move around it. If you need extra space for loose gear, see our Large Storage Units in Bunbury.
Caravan Storage Dimensions: Matching Unit Size to Caravan Type
Once you have your measurements, convert them into a required bay size. Once you have confirmed your access requirements, you can find the best caravan storage near you. Most owners underestimate this because they compare the caravan’s length to the unit’s length and stop there, ignoring width, height, the drawbar and the clearance needed to actually use the space.

A Simple Sizing Method You Can Apply Today
Use this four-step method to calculate the minimum bay size your caravan needs, for any caravan type and any storage facility.
- Start with the full footprint. Take your measured overall length (drawbar tip to rear) and overall width (widest point, including awning cassette or side fittings).
- Add side clearance. Add a minimum of 300 mm to each side so you can open the caravan door, reach the wheels, and walk past. That is 600 mm on width in total.
- Add front and rear clearance. Add at least 500 mm at the drawbar end for hitching and manoeuvring, and 300 mm at the rear so you are not reversing blind against a wall.
- Check height separately. Add at least 200 mm above the highest point (roof vent, air conditioner, aerial) to allow for the door opening and any overhead structure.
The result is your minimum usable internal size. If a facility quotes a bay smaller than this on any dimension, it will not work, regardless of the advertised size.
Measure in millimetres and keep the numbers on your phone. Facility staff can confirm a bay in seconds if you give them exact figures rather than “about six metres”.
Worked Examples by Caravan Type
The table below shows typical measured dimensions and the minimum bay size each caravan type needs. These are illustrative, always substitute your own measurements.
| Caravan type | Typical overall length | Typical width | Typical height | Minimum bay size (L × W × H) |
|---|---|---|---|---|
| Pop-top (compact) | 4.5 m | 2.1 m | 2.0 m (roof down) | 5.3 m × 2.7 m × 2.2 m |
| Touring caravan (mid-size) | 6.0 m | 2.3 m | 2.6 m | 6.8 m × 2.9 m × 2.8 m |
| Off-road caravan | 6.5 m | 2.4 m | 2.9 m | 7.3 m × 3.0 m × 3.1 m |
| Large caravan / fifth-wheeler | 8.0 m | 2.5 m | 3.2 m | 8.8 m × 3.1 m × 3.4 m |
A few things to note:
- Pop-tops gain height flexibility. With the roof down, a pop-top may fit an enclosed unit that a full-height touring caravan cannot. Confirm the door opening height, not just the internal ceiling height.
- Off-road caravans are taller and wider than they look. Raised suspension, roof racks and solar panels push both height and width beyond the manufacturer’s base figures.
- Fifth-wheelers need the most front clearance. The overhang above the tow vehicle means a longer drawbar area and higher hitch height, check both before booking.
How Accessories Change the Footprint
Accessories are the most common reason a caravan that “should fit” does not. Add these to your measurements before choosing a bay:
- Bike racks, a rear-mounted rack can add 400-600 mm to overall length. A tow-ball-mounted rack adds length at the front instead.
- Awning cassette, a fitted roll-out awning typically adds 100-150 mm to width on one side.
- External gas bottles and storage boxes, add width and sometimes length at the drawbar.
If you remove accessories before storage, measure again without them. If they stay fitted, they are part of the footprint.
Storing a Caravan Alongside Another Vehicle
If you plan to store a caravan with a boat, trailer or second vehicle in the same bay, add the second item’s footprint and allow clearance between the two. Two vehicles in one bay need enough room to move one without moving the other, otherwise every trip becomes a shuffling exercise. See our Bunbury’s Boat Storage Facility and Jet Ski Storage in Bunbury options.
The advertised bay size is a starting point, not a guarantee. Your required size is your measured caravan plus clearance on every side. If your calculation lands within 200 mm of a bay’s limit on any dimension, choose the next size up.
Compare your calculated size with the storage options on our caravan storage page before you book.
Allowing Caravan Storage Clearance for Access and Manoeuvring
Clearance is where most storage plans fail. A unit can hold the caravan on paper but leave no room to open the door, reverse in or reach the hitch. The gap between internal dimensions and usable space is the most overlooked factor in caravan storage.
Internal Dimensions vs Usable Access Space
Advertised unit dimensions describe the walls, not the working space. Several things reduce usable area inside a bay:
Book Online in 3 Minutes & Get 50% Off Instantly →
- Door and roller-door tracks, a roller door’s tracks and mechanism can protrude 100-200 mm into the opening, reducing effective width and height.
- Structural columns and corner posts, common in larger warehouses, these can sit inside the nominal bay and reduce the clear width at the entrance.
- Turning space at the entrance, the apron outside the bay matters as much as the bay itself. You need room to swing the tow vehicle and caravan into line before reversing.
Ask the facility for the clear opening dimensions, the actual gap you drive through, rather than the bay’s nominal size. These are often different.
Concrete Clearance Guidelines
Use these minimums as a practical starting point, based on common caravan dimensions and typical towing setups.
| Clearance type | Minimum recommended | Why it matters |
|---|---|---|
| Side clearance (each side) | 300 mm | Open the caravan door fully; walk past to reach wheels and fittings |
| Front clearance (drawbar end) | 500 mm | Hitch and unhitch; manoeuvre the jockey wheel; connect breakaway cable |
| Rear clearance | 300 mm | Avoid reversing blind against a wall; access rear bumper and spare wheel |
| Overhead clearance | 200 mm | Door opening and overhead structures; roof vents and aerials |
| Entrance apron / turning space | Length of caravan + tow vehicle | Swing into line before reversing; drive out without multi-point turns |
If you need to walk all the way around the caravan, to check tyres, wash it, or access both sides, add 600 mm on each side instead of 300 mm. Owners who access their caravan regularly should plan for the larger figure from the start.
A tight fit is not just inconvenient, it is a damage risk. Scraping paintwork, tearing an awning, or clipping a roof vent on a door frame happens most often when the bay is sized to the caravan with no working margin.
How Often You Access the Caravan Changes the Space You Need
Your access frequency should influence your bay choice as much as the caravan’s dimensions:
- Seasonal users (once or twice a year): a tighter bay with side clearance for door opening is usually workable, provided you can still hitch and reverse safely.
- Regular users (monthly or more): plan for walk-around clearance on both sides and enough front space to hitch without moving other items.
- Owners who store accessories in the unit: add floor space for bikes, annexe panels, and camping gear, or choose a bay with a separate storage area.
A Measurement and Facility Confirmation Checklist
Before you book, work through this checklist. It turns a vague “will it fit?” into a confirmed answer.
Measure your caravan:
- Overall length from drawbar tip to rear-most point (including spare wheel or bike rack).
- Overall width at the widest point (including awning cassette and side fittings).
- Overall height to the highest point (including roof vent, air conditioner, aerial).
Confirm with the facility:
- Clear opening width and height of the bay door (not the nominal bay size).
- Internal clear dimensions, allowing for columns, tracks, and overhead fittings.
- Entrance apron size and turning space outside the bay.
Ask the facility to confirm the bay dimensions in writing, or take your tape measure and check the clear opening yourself before signing anything. A two-minute check prevents months of difficulty.
Manoeuvring: Plan the Reverse Before You Book
Reversing a caravan into a bay is harder than driving in forwards, and many facilities require it. Before you commit, think through the manoeuvre:
- Can you approach the bay in a straight line, or must you turn immediately before reversing?
- Is there room for the tow vehicle to swing as the caravan pivots?
- Will other stored vehicles or structures block your turning path?
A bay that fits the caravan but leaves no room to reverse into it is not suitable. Build the manoeuvre into your decision, not just the parked footprint.
Usable access space = clear opening dimensions minus door tracks, columns, and overhead fittings, plus the apron and turning room outside. Confirm all of these before booking, and size up if your caravan is close to any limit.
Checking Vehicle Height and Access Before You Book
Access is not only about the unit, the route to it matters too. If you are looking at a unit in Picton, our Large Storage Units in Picton WA and outdoor and container storage in Picton options are worth comparing for access and clearance.
Before you book, confirm the following with the facility:
- The internal height of the unit and the height of the door opening.
- The width of the entry path and any turns you must make.
- Whether the access gate or roller door opens fully for a combined vehicle and van.
Measure your tow vehicle and caravan combined height if unsure. A combined height taller than the door opening means the caravan will not fit, however well the unit suits its length and width.
Caravan Storage Preparation Checklist Before the Unit
Preparing the caravan properly protects it while stored. Work through this checklist before you move it in:
- Clean the exterior and remove dirt, salt and bird droppings.
- Empty the fridge, cupboards and water tanks, then leave the doors slightly open.
- Disconnect the battery or switch off the main isolator.
Protecting the tyres matters more than most owners realise, long periods parked on the same spot can flatten them and cause uneven wear, so plan tyre care early.
Your Next Step: Measure, Confirm and Book Your Unit
Start with the measurements. Write down the length, width and height of the caravan with all its fittings. Add a clear margin on every side for access and manoeuvring. Then confirm the unit’s internal size, door height and access route before you book.
Once you have a size in mind, compare options through our Caravan Storage in Bunbury range and book online.
Frequently Asked Questions
How big should a storage unit be for a caravan?
Measure the caravan’s overall length including the drawbar, its width including awning and mirrors, and its height including any roof-mounted equipment. Add a clearance margin on every side so you can open doors and walk around the van. Many owners find a unit slightly longer than the van, plus room to access the door, is the practical minimum. Confirm the internal dimensions with the facility before booking, as a listed unit size can differ from usable space once doors, rails and roller tracks are considered. Urban Self Storage can help you compare sizes against your caravan’s measurements.
Should I include the tow hitch and accessories when measuring a caravan for storage?
Yes. The tow hitch, drawbar, spare wheel carrier, awning and any external storage boxes all add to the footprint the caravan occupies. Measuring the bare van body alone often leads to a unit that is too tight once everything is attached. Measure the caravan as it will be stored, with the hitch in place and accessories fitted, and note any items you plan to remove. This gives you a realistic figure to compare against the unit dimensions.
How much clearance should I allow around a caravan in storage?
Allow enough space to open the caravan door fully, walk around the van without squeezing past, and reach the hitch and any storage hatches. A practical guide is to leave a usable walkway on at least one side and enough room at the front or rear to move the van in and out. The exact clearance you need depends on how often you access the van and what you store alongside it. Ask the facility how much manoeuvring space is available inside the unit, not just the advertised size.
What should I check before booking caravan storage?
Confirm the unit’s internal dimensions, door width and height, and whether the roller door opens fully. Check vehicle access and turning space for the tow vehicle, including the height of any entry gate. Ask about access hours, whether the site is covered or outdoor, and what security features are in place, including CCTV coverage. Use the caravan measurements you recorded to check that the unit fits with clearance on all sides.
Ready to find the right fit? Browse our caravan storage in Bunbury options and check your measurements against the unit sizes available. For help matching your caravan to a unit, find the right storage unit size using our size guide. You can also calculate your storage unit size step by step from your measurements.